[official] Proton Exora Bold And Prime

sorry mate for interrupting, a bit off here.
id like to ask weather any exora owner do have an issue of steering vibration at 110-120 provided that both front is ni perfect balanced (3x at the wheel shop). well i met the sc advisor and they are willing to check it next week. i do found another owner reporting for the same matter.
so if any of u guys did come across this, ill be glad to hear how the sc solve this problem if any..

and for the wind noise at the driver's side when driving at 80kmh. i have sort this out by diy easily. no more wind noise.

as well as cigarette lighter socket kaput simply caused by a middle lower (15amp) fuse replacement.

exore b cfe is a very good car. hope to solve the steering vibes for exora b to get 100/100 full marks.

bro, its easy.
1 fold the mirror
2 after its folded u can feel the hole or cavity underneath it that now its exposed as it is folded position.
3 fill up the holes or cavity with sponge or anything that can act like fillers ,myself i use small piece of paper but u can us batter material.
4. unfold it thus the mirror ,the fillers then will stay secure. unless you have the auto-fold of H-spec ,the filler need to tight or holds so that it wont drop off during auto-fold.
5. drive off at 80kmh,
6. come back to this forum for a testimony.

ok bro thats all, happy trying.

My remote key didn't work ie didn't lock or unlock when pressed but could use it to start engine.

So went to PE Section 13. Petaling Jaya. Was told to change transmitter for RM90+. Not under warranty (?). After changing couldn't start. The SC open up the key compartment and discovered the chip for immobiliser missing.

Luckily I found the chip, less than 5 mm, on my car set! Gave it to SC who just put in inside the key compartment. Could start the engine there after.

My complain is on the shoddy SC who misplaced the chip and the design of the key compartment which doesn't allow the chip to be fasten to it.

So be very careful when you open the it to change the battery. Don't let the chip fall out.

Bro ntc got sooo much free time...hehe
Bro,i belief all guys here wants to see yr chrome piping lah....post some pic pls...

That insulator u bought can be used to wrap the aircond pipe.i did that on the waja,pajero,kenari,blm.
If helps cool the aircond quicker and compressor wilk runs on lesser. Hence a tad saving in fc which means u can go mad with the throttle more often.
Just remember to only wrap the cold line.
Btw u are going to need a set of very flexible finger at some part.
Best thing i saw in above pic is the snow mat....hehehe
Seriously, it helps cleaning the carpet easier.

That t10 led, i dont advise unguys to buy it at car acc shop as the price is ridiculus,crazy, potong kepala.
Go to bike shop and ask.....i know2....stop gawking...its a hell lot cheaper there.

Bro ntc,that leather needs a conditioner fast as its not of the same quality as they installed in the v6 and waja.
Turtle wax does the job just fine.

spare the grease to plastic

This bro is noise buster... almost all part alr DIY....

Hi, new Exora user here.

jeng jeng jeng jeng... both are custom 2 inch piping... connector use samco 1